Controller with USB
Saving position
Adjust the desktop to your desired height. Hold down the "S" key until the display shows "S--". Press the "1" key to display "S-1" and the current height alternately. Press the "S" key to save the height at the first memory position. Repeat the same procedure for the "2" key and "3" key memory positions.
Change the displayed Unit（cm/inch）
Hold down the "S" key until the display shows "S--". Press the "up" key to display "Unt". Press the "1" key to display "Unt" and the current height in centimeters. Press the "S" key to save the unit as centimeters. Repeat the above steps, then press the "2" key to display the height in inches. Press the "S" key to save the unit as inches.
Manual Reset
Hold down the key until the display shows "E-1" and "rES" alternately, then release the key. Hold down the key again to move the desktop slowly down until the display shows "27.6 or 700". Release the key to finish resetting the height-adjustable desk.
|
|
|
|
|---|---|---|
Adjustable Height Range27.6"~47.3"/700mm~1200mm |
Adjustable Width RangeOne side 43.3"~59"/1100mm~1500mm The other side 46"~56"/116mm~142mm |
Desktop DimensionsWidth 23"~30"/600~700mm Length 47.2"~70.8"/1200~1800mm) and 47"~70.8"/1250~1800mm. |
|
|
|
|
|---|---|---|
Triple-MotorThe 3-motor system enhances durability and quiet operation, ensuring the desk moves evenly . |
3 Memory With USBYou can charge your phone, tablet or other devices. |
Sturdy LegsHeavy-duty powder coating steel frame with 3 legs, the desk can support up to 300lbs/136kg. |
Code meaning and Trouble shooting
1. E-1/RES&Manual resetting:
Refer to the progress of manual reset
2. E-2&Anti-Collision function:
It can be used normally after removing the obstacle. [If there is no resistance, follow these steps to set up: Step 1: Press and hold the "S/M" button until "OFF" is displayed, then press the up and down buttons until "P--" is displayed. Step 2: Note: (E-2 appears during the ascending process), press the "1" key to display the flashing "PXX". Press the UP key to increase XX value. Step 3: Press the "S/M" button again to display the height, completing the rising sensitivity setting.]
3. E-3&Plug detection:
It reminds you check whether any motors fail connected with control unit. Please connect the main cable again,wait at least 5 seconds.Connect all the plugs. Follow “Manual Reset ”procedure.